Monday, 7 November 2016

Submarines

This is my submarine.





In order to make my submarine work, I need to be able to change the volume of the submarine.I did this by cutting of the end to be able to sink quickly. I also had to use the balloon to control the negative positive and neutral buoyancy.

This was my in the process work.










This is the submarine video of how it works!

4 comments:

  1. Good Job, Maddie!
    You really kept it short, which I, personally, liked. You were very clear with your explanation in the video, which leaves the viewer with more knowledge then when they started watching the video. An area I suggest you improve on, is ending your video off with a short conclusion. I believe that it would really keep the reader thinking. Your voice in the video was very clear, and you obviously weren't distracted until the end. You did a spectacular job, all in all. Good work!

    ReplyDelete
  2. The video is great! The explanation was clear and good and it was not too long. Your voice was clear and again, your explanation was great! You did a very good job!

    ReplyDelete
  3. Maddie this was a great presentation with lots of important detail but I do feel like you should have explained the submarine a little more and a little bit more clear because you did not really say much about volume and mass.

    ReplyDelete
  4. I really liked the way you used words like density, and positive and negative buoyancy. One minor thing you could work on is using words like ballast tanks. For ex. My Submarines Ballast tanks were filled with water at this point. You did a fantastic job overall and used clear and concise information. Well done!

    ReplyDelete