Thursday, 11 May 2017

Locker Alarm Summative







             Our locker alarm didn't work. The way it was supposed to work was, the wires connected to the battery and the buzzer but one didn't connect to the buzzer. The one that didn't connect to the buzzer it connected to the lock instead. So the circuit was incomplete. The objective was when the robber opened up the locker the aluminium would swing and touch the buzzer to complete the circuit.  It is incomplete until the locker is opened, then it is complete. This is how we made it. First we attached the negative side of the battery to the negative side of the buzzer with two wires. Then we did the same thing again just with the positive side of the battery to the positive side of the buzzer. We crated a circuit by creating a motion powered incomplete circuit! We connected the battery to the top of the locker and the wires and everything else below it. The electrical currents (Flow) passed through the wires up to the battery and connected when the locker opened.







No comments:

Post a Comment